Traffic Light controller for Bulb or LED type traffic lights. Includes outputs for walk / Don't walk lights and night blinking patterns

Module:
- Eight Sequenced outputs for 4 way traffic control and walk / don't walk lights
- Micro-proccessor controlled circuit with preprogrammed sequences.
- Voltage regulator on circuit board to enable voltages from 7 to 14 VDC to be used
- Sequences are programmed to turn on and off for a realistic Traffic Light look.
- Will work with Bulb type lights or LEDs common anode LED lights
- Walk light output included in module, but can be used without walk lights
- Driver chip is included in the module and can operate lights up to 300ma per circuit
- Assembled circuit board is 1" x 2 3/8" x approx. 1/2" high 
- Works with Walthers Four Way Hanging Traffic Light 933-2305
   (Runs a USA Traffic Light Sequence)
Standard Sequence Timing:
Red NS Green EW for 15 sec
Yellow EW Red NS for 3 sec
Red NS Red EW & Walk light 10 sec then Blink Don't walk for 6 sec*
(Unit can be purchased without the Walk Sequence if desired)
Red NS Red EW for 2 sec after Don't walk light comes on
Red EW Green EW for 15 sec
Yellow NS for 3 sec
Red EW Red NS for 2 sec
Repeat sequence from beginning 
*Walk light sequence can be removed by request when ordering

Power supply Required:
- 7 to 14 volt DC required operate the circuit. The DC accessory output on most power packs will work.

Connections:
- 8 solder type outputs with individual holes for common and switched power

Included in Kit
-The Traffic Light Control Kit comes with the circuit board, all components, 8 Outputs, Driver Chip, Hook up wire and complete instructions.
 
Options available:

- Assembled & Tested Circuit Board ready for hook up to traffic lights. Pushin Connector & 22-24 gauge hookup wire included with assembled unit!
- Custom Programming

Kit requires assembly by soldering. A small 15-25 watt soldering iron and solder is required for assembly. If you are uncomfortable with assembly, it can be ordered fully assembled & tested. Note: Assembly does not include wiring to optional traffic lights if purchased!